Appliance Repair in 19146 · Graduate Hospital & Point Breeze

In a basement, a small washer leak puddles on concrete. On a second floor, the same leak soaks the subfloor and shows up as a stain or drip on the ceiling below, often before anyone notices water near the machine. Because of that, the first job after a leak is finding the true source, not just replacing the most likely part.

Common culprits include a supply hose that has split or loosened at the valve, a drain hose that has slipped out of the standpipe, a clogged drain that backs water up and over the box, a torn door boot on a front loader, a cracked tub or a failing pump seal. Suds from too much detergent can also overflow a high-efficiency washer. Each leaves a different pattern, so note when the water appears: during fill, during the wash, or during the drain and spin.

After any leak, turn off the supply valves and stop using the machine until the cause is known. A drain pan with a line to a drain, braided supply hoses and a water sensor on the floor are inexpensive ways to limit damage the next time. If the ceiling below got wet, keep an eye on it and have it dried out properly.

Make sure there is room to pull the washer forward, and find the shutoff valves in the closet. Photos of the ceiling stain and of the water under the machine help the technician narrow things down. Parking can be tight on the smaller streets, so mention any nearby spot or driveway we can use.