Electrolux Stove Repair in Philadelphia

Here is the equipment behind an Electrolux stove call: an Electrolux stove top uses induction, radiant glass or sealed gas burners, and some electric models add a bridge element.

Repairs on these stoves usually involve burner igniters, infinite switches, bridge element connections, and spark modules. Put simply, the complaints are burner lights then dies, bridge element not heating, and clicking that won't stop. For a gas burner that lights and then dies, reset the burner cap so it lies flat and centered on the base. Clicking that continues after the burner lights usually means moisture on the switch or a failing spark module.

On Electrolux electric stoves the bridge element links two zones using additional wiring and switch contacts, so if the bridge stays cold while both round zones heat, that switch path is the likely fault. Sealed gas burner caps have to sit centered, or the flame lifts off and goes out. Heavy use wears infinite switches, which are cheap to replace.

If you smell gas around a stove, leave the house without touching light switches and call PGW or 911 from outside before calling anyone else. Before quoting, we clean and dry the suspect igniter and try again; that alone solves plenty of no-light complaints.

Since a large part of the North American Electrolux line is built on Frigidaire platforms, a fault and its repair often apply to both, though steam components and control boards tend to be specific to each model. Even a routine job such as the burner igniters gets a written estimate first, and our 90-day parts and 30-day labor warranty applies once it is done.

Let burner caps and heads dry completely after cleaning before you put them back. If the trouble is bridge element not heating, a short video of the symptom helps us arrive prepared.