Roper Stove Repair in Philadelphia

We begin every Roper stove repair with the product line, and A Roper stovetop is a basic coil electric or open-style gas top designed to be easy to service.

The familiar Roper stove culprits are worn coil element, scorched receptacle, bad infinite switch, and clogged burner ports. The calls we get tend to mention coil won't heat, burning smell, and uneven burner flame. Before using that burner again, lift out the drip pan and check the receptacle for scorched or melted wiring. On an electric coil stove, a burner that heats only on high points to a failing infinite switch.

Diagnosis on Roper's simple gas and coil tops is easy, since a fault is usually limited to a single burner, its switch or its receptacle. Spills can clog open gas burners and make the flame uneven. The parts are low-cost Whirlpool components, so repair is practical.

Many older Philadelphia homes cook on gas supplied by PGW, and a gas stove with a lazy or yellow flame needs its ports and air setting checked. A stove visit starts at the burner that is misbehaving, with its igniter, cap, ports and switch, then the spark module or element supply.

If a surface coil on a Roper range is dead, the element or its receptacle has usually burned out. Once the diagnosis confirms the cause, whether the worn coil element or something else, the estimate goes in writing and the repair is warranted.

Clear burner ports with a straightened paper clip, not a toothpick that can snap off inside. Same-day visits for burning smell and other Roper stove problems are possible when the schedule allows.