Amana Washer Repair in Philadelphia

Start with the basics of the line: Amana washers are mostly agitator top-loaders with a handful of basic cycles. A few front-load models round out the line.

The failures that repeat across Amana washers are lid switches, drive couplers, drain pumps, and inlet valves. Owners usually describe one of these: won't spin, won't drain, and agitator not turning. If a top-loader fills and agitates yet won't spin, press the lid strike; no response often means the lid switch has failed. Banging on spin is more often worn suspension rods or shocks, or simply an unbalanced load, than bad bearings.

On agitator top-loaders the lid switch and drive coupler fail often, and both are cheap. Slow draining may come from debris inside the pump rather than a dead pump. Low-cost, widely available parts make Amana washers good candidates for repair.

New-construction rowhomes often put the washer in a second-floor closet, so a small leak from a hose or door boot reaches the ceiling below quickly. Watching the machine go through fill, wash, drain and spin shows where it stops, and that narrows the fault fast.

If an Amana top-loader fills but never agitates, suspect a bad lid switch or worn agitator dogs. Jobs such as the drain pumps come with a written estimate up front and a 90-day parts, 30-day labor warranty when they are finished.

Make sure the machine sits level, because an unlevel washer walks, bangs and wears out its suspension early. If you are seeing fills slowly, or anything else off with your Amana washer, book a visit and we will confirm the cause before quoting.