Thor Microwave Repair in Philadelphia

Most Thor microwaves are built-in microwave drawers meant to be installed beneath a counter or a wall oven.

The failures that repeat across Thor microwaves are drawer motor, magnetron, drawer position switches, and control panel. Put simply, the complaints are drawer stays shut, no heat, and unresponsive controls. When the drawer stops partway, wipe down the track and clear any obstruction before assuming the motor is bad. An over-the-range unit whose fan runs constantly may have a failed thermal sensor or control board.

A motor, gear train and position switches move a microwave drawer, so one that halts midway more likely has a track or switch fault than a heating problem. The cooking side uses a standard magnetron system that carries the same high-voltage danger as any other microwave. Since the drawer is fitted into cabinetry, fixing it is often simpler than tracking down a replacement that fits the opening.

Surges when the power returns after a thunderstorm are a common reason a microwave control board fails without warning. The door interlocks come first, because a microwave will not run unless every one of them works.

Rather than coming from general distributors, Thor parts are usually supplied by the company's in-house parts department, and a wait of one to two weeks is typical. Jobs such as the drawer motor come with a written estimate up front and a 90-day parts, 30-day labor warranty when they are finished.

Do not use an over-the-range microwave as a shelf for heavy items. If you are seeing no heat, or anything else off with your Thor microwave, book a visit and we will confirm the cause before quoting.