Maytag Microwave Repair in Philadelphia

Here is the equipment behind a Maytag microwave call: Maytag's microwaves are built on Whirlpool platforms, mainly as over-the-range models with vent fans, along with a few countertop units.

Repairs on these microwaves usually involve failed magnetrons, faulty door switches, motors on the vent fan, and failed touch pads. Owners usually describe one of these: no heat, vent fan dead, and keypad unresponsive. Food staying cold while the turntable and light work points to a high-voltage failure, so keep the cabinet closed and leave it to a technician. If it will not start with the door closed, a failed door switch is the likely cause.

Because over-the-range units pair the microwave with lights and a vent fan, a fan failure can be fixed without going near the high-voltage section. A model that runs without heating may need a magnetron, and the unit's age decides whether that repair is worthwhile. A dead microwave is often caused by a failed door switch, which is common and cheap to fix.

In condo kitchens, over-the-range units vent grease into tight spaces, so clogged filters and fan failures are frequent. The door interlocks come first, because a microwave will not run unless every one of them works.

Because Maytag parts travel through Whirlpool's distribution network, most are on hand within a day or two, and many share Whirlpool part numbers. Even a routine job such as the motors on the vent fan gets a written estimate first, and our 90-day parts and 30-day labor warranty applies once it is done.

Clean the grease filters on an over-the-range unit about once a month. If the trouble is sparks inside the cavity, a short video of the symptom helps us arrive prepared.